condor d.c. power supplies, inc., a subsidiary of sl industries, inc. 805-486-4565 ?(800) 235-5929 fax: (805) 487-8911 http://www.condorpower.com 250, 350 watts multiple output telecom mtc series model pwr output #1 output #2 output #3 output #4 max-254-1205 250 +5v @ 35a +12v @ 8/12a pk -12v @ 4a -5.2v @ 2a max-353-0512 350 +5v @ 50a +12v @ 8/12a pk -12v @ 4a max-354-1205 350 +5v @ 50a +12v @ 8/12a pk -12v @ 4a -5.2v @ 2a max-354-1212 350 +5v @ 50a +12v @ 8/12a pk -12v @ 4a 12v @ 2a max-354-1224 350 +5v @ 50a +12v @ 8/12a pk -12v @ 4a +24v @ 1.5a standard max series model pwr output #1 output #2 output #3 output #4 mtx-253-0512 250 +5v @ 35a +12v @ 8/12a pk -12v @ 2a mtx-254-1205 250 +5v @ 35a +12v @ 8/12a pk -12v @ 2a +5v @ 1.5a mtx-254-1212 250 +5v @ 35a +12v @ 8/12a pk -12v @ 2a +12v @ 2a small computer mtx series model pwr output #1 output #2 output #3 msc-353-0512 350 +5v @ 30a +12v @ 20/2 a pk -12v @ 4a mass storage msc series max-250 max-350 mtc-250 mtc-350 MTX-250 msc-350 featuring: over 3 watt/in 3 power density 80% overall efficiency meets international safety agency requirements all outputs regulated 1% high peak currents for motor starting system air or self-cooling options ac automatic line selection option available in 24, 28, or 48 vdc input the appropriate mtc, max, or mtx in your telecom product gives you the out- puts you need for isdn, lan, and t1 applications and standard voice and data networks. high-current auxiliary outputs provide regulation characteristics for prop- er operation of line drivers, network inter- faces and rs232-type outputs. or, use a 9-inch msc in your computer-based product for needed output regulation, power for 50 amps of logic and four hard disk drives. and, you can increase power by 40% as you add peripherals ?without redesigning for a larger power supply by upgrading from the mdt 160/220 series. check the specifications of these low- profile, 9-inch switchers that give you more design freedom. model pwr output #1 output #2 output #3 mtc-253-0515 250 +5v @ 30a +15v @ 4a -15v @ 4a mtc-353-0512 350 +5v @ 45a +12v @ 6a -12v @ 6a mtc-353-0515 350 +5v @ 45a +15v @ 5a -15v @ 5a option c option v
condor d.c. power supplies, inc., a subsidiary of sl industries, inc. 805-486-4565 ?(800) 235-5929 fax: (805) 487-8911 http://www.condorpower.com 250, 350 watts 9 x 5 x 2.5 max, msc, mtc, mtx function 115 vac 230 vac connector input select short open 0.187 male fastons tb1- line line 1 tb1- neutral line 2 tb1- safety ground safety ground ac input function max, mtc, mtx msc connector output #1 terminal marked +v terminal marked com output #2 tb2-3 (+) tb2-2 (+) tb2-4 rtn (common) tb2-1 rtn (common) output #3 tb2-5 (? tb2-3(? tb2-4 rtn (common) tb2-1 rtn (common) output #4* tb2-1 (+) (if provided) tb2-2 (? *rtn connected to common only if output is polarized in product selection chart dc output barrier strip #6-32 screws 3/8?centers bus bars #10/32 screws barrier strip #6-32 screws 3/8?centers function location notes connector j1-1(+ s) output #1 sense j1-2 (?s) output #1 sense rtn ac power fail or j1-3 (pf) reference to j1-2 dc power good* inhibit j1-4 (ih) short to j1-2 *optional function status and control amp mta type #640456-4 pin header (locking) remote sense specifications: all models input ac input: 90-132 vac/180-264 vac, 47 to 63 hz. user selectable. see option ??for automatic line selection. internally fused for 10 a. inrush: cold start ac current is less than 10 a at 115 vac and 18 a at 230 vac. for mtx models, 10 a at 115 vac and 20 a at 230 vac. limited by thermistor. holdup time: 16 ms minimum after removal of power, at nominal line, full load. efficiency: 80% typical. brownout protection: holds regulation to 85 vac or 170 vac. output adjustability: user adjustable ?% minimum. line & load reg: ?% over ac input range and 0 to 100% load change. output #1 requires minimum load of 10%. ripple & noise: less than 1% p-p or 100 mv, whichever is greater. remote sense (output #1) : compensates for 250 mv total line drop. open sense lead protection. temperature coefficient: 0.02% per degree c. stability: 0.1% over 8 hours after 30 minutes warm-up. transient response (output #1) : output voltage returns to within 1% in less than 500 ? for a 50% load change. peak transient does not exceed 5%. overload protection: all outputs are protected against overload and short circuit. automatic recovery upon removal of fault. overvoltage protection (output #1) : protects load against power supply induced overvoltage. trip point is factory set so that output voltage cannot exceed 136% of nominal. remote inhibit: contact closure to the negative sense line drops output power to nominal zero. reverse voltage: protected against reverse voltage up to supply current rating. environmental thermal protection: shuts down power supply if overheated. automatic recovery. temperature range: 0 to 50? at full ratings. derate to half power at 70?. safety agencies: most models are approved to ul1950; csa 22.2 #234; iec 950 and t?v en60950, class 1 selv., ce 72/23/eec/93/68eec (low voltage directive). conducted rfi: meets fcc part 15, subpart j, class a; en55022 class b; cispr 22 class b. cooling: 30 cfm required to achieve full ratings. output isolation: isolated from ground 50 vdc. options: option ?? ac auto-range: automatically selects proper ac line voltage range to enable power operation at either 115 or 230 vac without user intervention. option ?? cover: limits contact with power supply interior. option ?? fan/cover assembly: cover with integral ball-bearing fan provides proper cooling to achieve full ratings at 50? ambient temperature. option ?? dc power good: provides a ttl ??open collector when output #1 is above 4.6 v nominal. not available if option ??is selected. max, msc, mtc, mtx with option f 3.9 lbs - 1.8 kgs max, msc, mtc, mtx 3.4 lbs - 1.5 kgs option ?? ac power fail: provides ttl ?? 5 ms before output voltage goes out of regulation band upon loss of ac power. vmebus compatible, provides 48 ma sink current capability. not available if option ??is selected. option ?? fan/cover assembly: low profile, end venting cover with integral ball-bearing fan. consult factory for other available options. *9.05 229.87 for mtx dimensions: inches millimeters (l) (n) ( )
|